Skip to main content

For discussion:

For those measurers still using pneumatic tires, finding out you have a slow leak after you have left the measured course is a hassle. It means you have to go back out and adjust the course. But, it also means you may not have an accurate measurement, even if you are within the tolerance factor. Due to the leak, the second measurement really wasn't accurate, based on the initial calibration.

Or, you calibrate near home, drive to a remote course, and have a flat during your measurement. What a drag.

What I am proposing is setting up a very quick calibration-check course at the measured course. I propose that, after completing a pre-calibration on a certified cal course, we calculate the clicks required for a 100 yard or 100 meter course. When arriving at the measurement course, lay down a piece of marked duct tape, and ride 100 yards or meters. At that point, place another piece of marked tape. Ride the new cal-check course at least one more time, to make sure your clicks are correct. (If you have a slow leak, it won't be apparent at this time.)

When the measurement is complete, ride the cal-check course twice more, to see that you have the same number of clicks as you had before your measurement rides, or very close to it. If so, you are good. If not, you can adjust your course while you are there. If a leak is indicated by a large variance in clicks, you would have to re-ride anyway, but you won't spend the time doing a post-cal near your home.

This is a simple process for one person to do, as opposed to setting up a taped course.

If the cal-check shows consistent clicks, would a formal post-cal be required?

Taking it a step further, if one had a flat, would it be permissible to use this cal-check course to re-calibrate? Especially, if one rode a previously-marked mile for verification?

Thoughts?
Original Post

Replies sorted oldest to newest

If someone sent me data such as is proposed here I would give it serious consideration, and not just shoot it down because it's a bit non-standard. The occasional deviation from Our Way can perhaps be tolerated, especially when the alternative is to send someone out to do it all over again. We need to be open to new ideas.

Punctures are always a worry. Solid tires give reliability, but I abandoned them years ago, as I found the riding qualities unpleasant. I now use pneumatic tires named "Armadillo" and have never had a flat using them. Of course, I have had only one or two flats in 30 years of measuring, so maybe the extra cost of the Armadillos is unnecessary.
Duane,

This is a great idea and it wouldn't be limited to the slow leak scenario. It would protect you against a higher count on the post-cal, regardless of reason that happened.

If your post-cal ride on the temporary course gives a higher count (pretty rare I think), you would adjust the course based on that new cal constant, plus maybe a meter or two. When you get home you do a real post-cal to make it official.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×