Reply to "Two Questions"

nevilleRRTC Validations Chair

Question 1: Pete Riegel described a possible procedure under "Addition to measurement" below on Nov 17 04.

Question 2:I notice that you converted your primary measurement unit (counts or revs) to meters. Also, Ron suggests taking measurements with a steel tape. These sort of procedures are described in the official on-line manual, but as I pointed out in MN a few months ago, conversions to standard measurement units are quite unnecessary.
Suppose I measured a an old course from start to finish and found it to be 400 counts too short. If I wished to make a correction at the start, I would turn around and measure back to the old start. I would then note the counts, and if I had more than 400 to go on this measurement, I would make the new start at the completion point. Otherwise, I would ride an addtional 400 counts and make the new start there. I would make an accurate correction without having to know what it is in meters or getting out the steel tape.

5/16/051:49 PM

<ul id="{%=id%}ButtonGroup" class="button-group h-popup-buttons even-button-group even-1">
    <li id="{%=id%}Okay_buttonContainer"><a id="{%=id%}Okay" href="javascript:void(0);" class="button success no-margin-bottom h-alert-modal-ok-button" role="button">OK</a><script type="text/javascript">
        (function() {
            function {%=id%}Okay_click(event, data) {
            {%=id%}Popup.hide();
        }
        
                $('#{%=id%}Okay').on('click', {%=id%}Okay_click);
        })();
    </script></li></ul><a href="javascript:void(0);" class="close-reveal-modal" aria-label="Close Modal">&#215;</a><div class="last-modal-focus focus-utility-element" tabindex="0"></div>
</div>
<script type="text/javascript">
        (function() {
            {%=id%}Popup = new SS.Popup.ModalPopup('{%=id%}');
        })();
    </script>

Skip to main content

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...